RTL (P0 pre-bringup findings R-1/R-2/R-3/R-5/R-6):
- mti_canceller: add use_long_chirp input and waveform-boundary mute
so the long->short transition in mode 01 no longer subtracts across
heterogeneous waveforms (R-1). Prev buffer is overwritten in-flight
at the boundary so the next same-waveform chirp subtracts cleanly.
- ad9484_interface_400m: 2FF sync of mmcm_locked into the 400 MHz
domain before gating reset_n_gated (R-6).
- cic_decimator_4x_enhanced: correct max_fanout narrative (R-3).
- ad9484_interface_400m: strip stale pblock comment, note 3.0 ns
max_delay instead (R-2).
- mti_canceller / doppler_processor: 200T-20km WARNING banners
flagging the broken 4096-bin path (R-5). 9-bit BRAM address aliases
silently until rewritten.
- adc_clk_mmcm.xdc: relax set_max_delay from 2.700 -> 3.000 ns,
closes WNS with headroom on 50T build.
- radar_receiver_final: wire use_long_chirp into mti_inst.
Architecture-bump finalization (2048-pt range FFT, 512 range bins,
32 Doppler bins -> 16384 output cells per frame):
- tb/cosim/radar_scene.py: FFT_SIZE 1024 -> 2048, RANGE_BINS 64 -> 512.
- tb/gen_mf_golden_ref.py: N 1024 -> 2048.
- Regenerate all affected hex goldens (MF cases 1-4, Doppler inputs
+ py goldens, receiver integration golden_doppler.mem 2048 -> 16384).
- tb_radar_receiver_final: widen range_bin_out 6 -> 9 bits, bump
GOLDEN_ENTRIES 2048 -> 16384, expand bitmaps/arrays to 512 bins,
update all check messages and thresholds.
- tb_mti_canceller, tb_fullchain_mti_cfar_realdata: tie/pass
use_long_chirp so compile still works after RTL port add.
Test-suite hardening (coverage audit findings):
- tb_mti_canceller T12: 10 new assertions exercising R-1 waveform-
boundary mute across a long/long/short/short/long sequence. Catches
a regression that re-enables subtraction across the boundary.
- tb_fir_lowpass: replace tautological check(1'b1, ...) on coefficient
symmetry with a real hierarchical check coeff[k]===coeff[31-k];
replace always-pass overflow check with a well-driven (not X/Z)
assertion on filter_overflow.
- tb_matched_filter_processing_chain: replace three always-pass peak-
bin placeholders with peak-to-mean-|out| > 2x ratio checks (catches
flat/zero output that the old tautologies silently accepted).
- tb_cdc_modules M2: replace always-pass narrow-pulse check with a
well-defined-output assertion on the synchronizer.
- tb_nco_400m: replace always-pass freq-switch check with a swing +
no-X assertion across 200 post-switch samples.
- tb_system_e2e G12.1: replace check(1, ...) with test_num > 20 so
it catches a stalled TB that skipped prior groups.
- tb_multiseg_cosim TEST 4: replace always-pass placeholder with a
bitmap that asserts segment_request visited all 4 values.
- tb_mf_chain_synth and tb_fullchain_mti_cfar_realdata: add DEPRECATED
headers plus \$fatal guards (ifndef ALLOW_STALE_*) so they cannot
be silently re-enabled in CI with stale 1024-bin goldens against
current 2048-pt RTL.
Regression: 32 passed, 0 failed. MTI TB grew 30 -> 39 checks;
receiver integration grew 17 -> 18 checks with 16384/16384 golden
match at tolerance +/- 2 LSB.
The AD9484 OR (overrange) LVDS pair is routed on the 50T main board to
xc7a50t-ftg256 bank-14 pins M6/N6 but was previously left unconnected at
the top level. Plumb it through the full stack so saturation at the raw
ADC boundary shows up in the existing overflow aggregation:
- ad9484_interface_400m: add adc_or_p/n inputs, IBUFDS + IDDR capture of
both phases in the BUFIO domain, re-register into the clk_400m BUFG
domain, OR rise|fall into adc_overrange_400m output.
- radar_receiver_final: stickify adc_overrange_400m in clk_400m, CDC to
clk_100m via a 2FF ASYNC_REG chain (same reasoning as F-1.2's
cdc_cic_fir_overrun — single-bit, latched low→high, GPIO-class
diagnostic), OR into the existing ddc_overflow_any aggregation.
- radar_system_top: expose adc_or_p/n top-level ports and pass through.
- xc7a50t_ftg256.xdc: anchor M6/N6 as LVDS_25 DIFF_TERM, with the same
DCO-relative input-delay constraints as adc_d_p[*].
- xc7a200t_fbg484.xdc: IOSTANDARD/DIFF_TERM set; PACKAGE_PIN left as a
documented TODO — the 200T dev-board schematic has not been checked
and the 200T build will need the anchor filled in before place/route.
The IBUFDS primitives in ad9484_interface_400m.v hardcoded LVDS_25 and
DIFF_TERM TRUE, which overrode XDC constraints. On the XC7A50T (Bank 14
VCCO=3.3V), this caused a BIVC-1 DRC error: LVDS_25 requires VCCO=2.5V,
conflicting with adc_pwdn (LVCMOS33, VCCO=3.3V) in the same bank.
Changes:
- ad9484_interface_400m.v: IBUFDS parameters changed from LVDS_25/DIFF_TERM
TRUE to DEFAULT/DIFF_TERM FALSE, delegating control to XDC per target
- xc7a50t_ftg256.xdc: Re-enable DIFF_TERM TRUE (safe now that RTL does not
hardcode LVDS_25), update DRC Fix History with correct root cause
